Easy French Polish
Product useLiberon Easy French Polish is ideal for use on furniture, carved woodwork and artefacts in rare or exotic woods. Easy French Polish Clear will beautifully enhance the wood’s natural finish.
PreparationEnsure the surface is clean and bare, removing any wax finishes with Liberon Wax and Polish Remover and any varnish with Liberon Fine Wood Stripper. Sand with extra fine abrasive paper and remove any dust with a tack cloth.
ApplicationUsing a good quality brush or cloth apply a thin coat of Liberon Easy French Polish. Work with the grain of the wood and avoid overlapping between strokes. Allow a drying time of 3 to 4 hours between coats. Gently rub down the dried coat using extra fine abrasive paper or Ultra Fine (0000) Steel Wool for a smooth surface. Use a tack cloth to remove any dust.
Apply as many coats as necessary, following the same instructions. Three to four coats are usually sufficient to achieve a quality finish.
Important: Always test product first on a spare surface or inconspicuous area for colour, compatibility and end result.
Heath and SafetyHighly flammable. Flash point below 22°C. Keep out of the reach of children. Keep away from sources of ignition No smoking. Do not empty into drains. Take precautionary measures against static discharges. Use only in well-ventilated areas. If swallowed do not induce vomiting: seek medical advice immediately and show this container or label.
Charles Watson (Ironmongers) Ltd.125 Pellon Lane, Halifax. HX1 5QN
Telephone: 01422 251251 Fax: 01422 firstname.lastname@example.org
Company Reg. No: 532657 VAT Reg. No: 184 022 88